<![CDATA[Upload Problem]]>I'm a beginner of ST-LINK/V2 and STM32 tools.
Please take a look on my error message.
1.jpg 2.jpg

]]>https://forum.aceinna.com//topic/46/upload-problemRSS for NodeThu, 11 Jun 2026 16:49:38 GMTThu, 11 Jul 2019 01:31:08 GMT60<![CDATA[Reply to Upload Problem on Thu, 11 Jul 2019 01:31:49 GMT]]>I'm a beginner of ST-LINK/V2 and STM32 tools.
Please take a look on my error message.
1.jpg 2.jpg

]]>https://forum.aceinna.com//post/126https://forum.aceinna.com//post/126Thu, 11 Jul 2019 01:31:49 GMT<![CDATA[Reply to Upload Problem on Fri, 12 Jul 2019 01:04:48 GMT]]>You can try this way on all OpenIMU300ZA.json files in your system:
change the sentence from: "offset_address": "0x08010000"
to : "flash_start": "0x08010000"

the file location as reference: .platformio\platforms\aceinna_imu\boards

]]>https://forum.aceinna.com//post/127https://forum.aceinna.com//post/127Fri, 12 Jul 2019 01:04:48 GMT<![CDATA[Reply to Upload Problem on Fri, 12 Jul 2019 05:29:56 GMT]]>@cek Thanks,i'll try it.

]]>https://forum.aceinna.com//post/131https://forum.aceinna.com//post/131Fri, 12 Jul 2019 05:29:56 GMT<![CDATA[Reply to Upload Problem on Sat, 13 Jul 2019 02:21:35 GMT]]>@cek It works, thank you for your help.

]]>https://forum.aceinna.com//post/132https://forum.aceinna.com//post/132Sat, 13 Jul 2019 02:21:35 GMT<![CDATA[Reply to Upload Problem on Sat, 13 Jul 2019 03:03:49 GMT]]>I'd like to describe my case briefly, by this way, if anyone face a similar problem, you can refer to the solution mentioned above.
For my case, compiling is success, but after connect the OPENIMUZA300 and PC via ST-LINK/V2, upload problem happened.
Warning message screenshots are posted in this page.

]]>https://forum.aceinna.com//post/133https://forum.aceinna.com//post/133Sat, 13 Jul 2019 03:03:49 GMT