Hello,

I have a few questions regarding MCR1101-50-5, and it's overcurrent protection.

1. Is the FAULTB state "remembered" after resetting the IC's supply?
   If so, would it be possible to clear the FAULTB signal this way?
2. Is the VOUT pin still giving reading after the fault is detected ?
3. Is it possible to run a wired-or network with multiple VOC pins connected to the same switch? This way resetting all sensors at once is possible.

I have multiple sensors running simultaneously, and would like to reset the state of them using as few wiring as possible.

Best regards,
Tom