Start-up error: "No task to run found. Configure task…."

Recently purchgased OpenIMU 330BI hardware and installed. Added ACEINNA extension and imported a basic example. Can NOT build the project, receive the message, "Select the task to run / No task to run found. Configure task…." Spoke to an ACEINNA FAE today without success. Re-installed the VS code and problem is not resolved. FAE suggested posting on the forum to see if this problem has been resolved by someone else?

0efc1dca-b620-4630-b130-4f0d9a7bb7c8-image.png

Yes, I have tried both buttons. The message is the same: No Task found / create task.

Have you tried the two buttons in the fig below?
7195b15e-295a-4c11-9a3f-9e3d4f9ace17-图片.png

Log in to reply