Hello everyone.
I recently bought the openimu300ri to help in our AGV development.
But cannot seem to figure out how to connect and log the data to the Acienna Navigation Studio.
-l5vw8q81.jpeg)
I am using a MCP2200 isolated usb to uart board. Wit the rx of the imu connected to the tx and the tx of the imu to the rx.
-l5vw7y0r.jpeg)
I have supplied a 12V and less than 0.1A to the imu.
-l5vw6tum.jpeg)
But it is still not being detected in the NAV-VIEW. I checked the com and it shows up in the com port with baud rate to 38400.
-l5vwm91t.png)
The webserver does not detect it either and remains in this current image all the time without any updates.
-l5vw6fbn.jpeg)
-l5vw61pe.jpeg)
Any help regarding this matter would really help me very much.