Here is a screenshot of the server log file:
Posts made by say
Here is a screenshot of the Visual Studio Code terminal window after running server.py. It has the same output as Server_win32_1.1.1. The DOS command window disappears very quickly after running Server_win32_1.1.1, so the picture is blurry.
I downloaded the IMU Server Ready-To-Use (Windows) using the Chrome browser and installed it as shown above. I still cannot connect to the IMU using ANS. After opening ANS, when I run Server_win32_1.1.1, a DOS console window opens briefly as shown here:
It gives the message as shown: "Cannot configure port, something went wrong. Original message: .."
How should I correct this problem?
I performed the steps above exactly as listed. Here is a screenshot of the ST-LINK Utility after successfully uploading the bin file, locking the sectors, and restarting the IMU:
I immediately saw good data over HTerm on COM14:
However, I still cannot connect to the OpenIMU Monitor at developers.aceinna.com/devices/record-next
What next steps should I take?
I cannot get any data from the IMU over HTerm.
After establishing communication with the ST_LINK Utility, I tried to connect to each of the 5 COM ports using HTerm while the ST-LINK/V2 debugger LED is flashing alternately green and red. I could not get any data from the IMU over HTerm.
I also disconnected the IMU with the ST-LINK Utility and then again tried to connect to each of the 5 COM ports using HTerm while the ST-LINK/V2 debugger LED is constant red. I could not get any data from the IMU over HTerm.
I installed the EEPROM bin file which you sent to me exactly according to the instructions under section 5 of the link above, starting at location 0x08000000, with a size of 0x30000. I set the 6 Option Bytes afterward and restarted the IMU board. I could not get the IMU to connect. I repeated the procedure again. I still cannot connect to the IMU with the OpenIMU Monitor. What should I do?
Here's a screenshot of the data from HTerm on COM14:
The last 6 Pages (58-63) are write protected when I first open the Target > Settings > Option Bytes window.
My Serial Number from the label on the OpenIMU330BI EVK is:
if you follow the link https://forum.aceinna.com/topic/75/update-openimu330bi-new-firmware and get
I followed the link you provided: https://forum.aceinna.com/topic/75/update-openimu330bi-new-firmware
The webpage at the link provided above shows a set of screenshots for the ST-LINK program. I was not able to find the data package 55 55 7A 31 XX XX anywhere in that webpage. Can you verify that you sent me the correct link?