Posts made by JimmyEG

Dear Cek,

Here is the question from data logger supplier, maybe you can provide the answer to his question.

"If the CANedge2 is correctly connected to the Gyro CAN H/L - and the Gyro is broadcasting valid CAN data - then the CANedge2 will be able to log it. If the gyro utilizes a non-standard bit rate to broadcast the CAN data, this can be set in the CANedge2 configuration under the CAN_1 and CAN_2 sections. However, I think it would be simpler to first check if the Gyro is able to broadcast CAN data at a standard rate like 250k."

Can you understand what he is asking.

Best regards,
Jimmy

Dear Cek,
Our sensor is working to PC very well without putting that 120 resistance and CANedge is working in the sence that it was given power to the USB connected into channel2. My issue really is how to communicate sensor to the CANedge2 or say talk to each other. Is there any BAUD rate to change to match?

Regards,

Hello Cek,

Thanks, we still preparing things and we will com back to you once we run the test as per your advice. Just one more question this CAN tester is use in the place of the CANedge2 data logger?

Regards,
Jimmy

Hello,

Here some photos to show that they working, but issue right at the moment is maybe how to configure the sensor using NAV-View. I am sending this query while I am trying to configure it from the user manual availble. Appreciate if somebody can guide us and that will be more faster that me reading everthing here.

1. Photo 1 - showing the graphical diagram.
   
2. Photo 2 - showing the connection set-up.
   
3. Photo 3 - showing the power provided to both units.
   
4. Photo 4 - showing the connection to the PC.
   
5. Photo 5 - showing that the data logger is receiving the power.
   
6. Photo 6 - showing the sensor is working.
   
7. Photo 7 - showing the USB with the lights on.
   

I have already speak to the data logger supplier and they told me to speak to you guys on how to configure the sensor in order to capture the data from the sensor to the data loggers. They will be two sensors in one data logger to maximum the use of it.

Best regards,
Jimmy

We have tested our MTLT305D directly connected to a PC and was working. We have a data logger CANedge2 and tested both channels are working since we managed to power it up and a USB connected to the CH2 was powered by it. Now my query is how to configure the MTLT305D to connect to this data logger? Can anybody help me on this please.

Thanks.

Concerning DBC files, I want to know if these files can be transfer to EXCEL sheets and how to make them readable. Many thanks